canon scangear windows 10 not showing up

CANON SCANGEAR WINDOWS 10 NOT SHOWING UP HOW TO
CANON SCANGEAR WINDOWS 10 NOT SHOWING UP INSTALL
CANON SCANGEAR WINDOWS 10 NOT SHOWING UP UPDATE

Open the Printer properties screen in Windows.įrom the Printer properties window, select the Ports tab.Ĭonfirm that the Enable bidirectional support box is checked for the selected driver.

CANON SCANGEAR WINDOWS 10 NOT SHOWING UP INSTALL

The printer is connected to your computer or network before you install the printer driver.įollow the steps below to resolve the issue. The printer driver is installed before you complete a needed upgrade to the computer's operating system.

CANON SCANGEAR WINDOWS 10 NOT SHOWING UP HOW TO

but thanks for all your ideas really are appreciated.Learn how to troubleshoot the 'Cannot communicate with the printer' error message.

CANON SCANGEAR WINDOWS 10 NOT SHOWING UP UPDATE

I then tried to switch the 4400F to my wifes PC after update to Win10 but it would not work at all. My Mesh PC burned out hence recent purchase and move to this one. Which according to Windows helpdesk is not supported under Win10 That scanner worked fine using canonscan toolbox. When I upgraded to Windows 10 at the recent release date, this 4400F scanner was connected and on, after update to Win10 I had then a Canon 4400F scanner using canonscan toolbox, it worked fine with never any problems.

I used to run Windows 7 on my old rig a Mesh desktop with Asus mbrd. Unsure why, but this only worked on my PC not my wifes which is only a few months older than mine and also a Chillblast Desktop. The only small thing thats 'seems' to have a small improvement, I installed Java and since then the scanner will make more passes before stalling. Switched around the USB outlets - no change. I spent this morning checking the MBrd software, the makers Chillblast installed an Asus H81M-C MB and checked the Asus site and the Bios and Chips are all right up to date. I've seen on some forums a suggestion to run Scanner as if using Win7 (Compatibility mode)īut these referred to another Canon scanner model, then involved using older Canon Scangear software (Windows7), which I've tried, but also needed some additional lines of script added to the environment variables area, which I have no idea how to do or what to add even if I find the correct place to add the lines. Strange since the problem occurs on both scanners and Lide220 is new.Īnyone out there any idea how to work around this? Then Canon tell me the scanner is faulty and to get it repaired. Uninstall/reinstall software (lost count of how many times I've done this) and plug USB into another port also tried several ports. to restart.Ĭanon help/support are absolutely useless, guy told me to change USB cable (tried 3 cables) Have to either reboot PC, remove/disable scanner in Device Mgr.

It it manages one full sweep, preview gives result then I try pressing Scan and it either locks 30% of the way in and just hangs, or says its warming up and does nothing.Įventually (3mins later) I get pop-up saying USB cable disconnected Scanner has lost connection etc.

Same problem occurs on each scanner and on each PC.Īfter one Preview scan, scanner sometimes makes a full sweep, sometimes not quite all the way. I cannot get either this scanner (Lide110) or my other Canon Lide220 working. Since I now have Windows 10 on both my PCs. I have two Canon flatbed scanners on two desktop PCs which worked fine with Windows 7.

Canon scangear windows 10 not showing up